NOTICE Notice: This is an old thread and information may be out of date. The last post was 2106 days ago. Please consider making a new thread.
Results 1 to 7 of 7

Thread: Trackside Camera Groups

  1. #1
    Newer Member Gerda 3's Avatar
    Join Date
    Dec 2011
    Location
    Germany
    Posts
    10

    Question Trackside Camera Groups

    Hi everyone!

    Does anybody know, if it is possible to disable the trackside camera group "Cycle"?

    Thank you.

    Best regards,
    Gerda 3

  2. #2
    Registered Traveller's Avatar
    Join Date
    Oct 2010
    Posts
    276
    You can use the camera control keys-- view/set in rFactor-- to break the cycling. One key cycles through the cameras with each keypress. I think there is also a free camera mode where you can set the camera position.

  3. #3
    Newer Member Gerda 3's Avatar
    Join Date
    Dec 2011
    Location
    Germany
    Posts
    10
    Thatīs correct, but i want only give the option to switch between camera group 1, camera group 2 and camera group 3.

  4. #4
    Registered Lazza's Avatar
    Join Date
    Oct 2010
    Location
    Australia
    Posts
    3,451
    Does this line from the readme help?

    "Finally, if track-makers wish to start with trackside group 1 rather than the CYCLE mode, they can set "Trackside1First = 1" in the track GDB file."

    Edit: Just checked by trying this line, but all it does is make it default to Group 1 instead of CYCLE, and puts CYCLE at the end (so Group 1, Group 2, CYCLE, in that order... rather than CYCLE, Group 1, Group 2)

    This would suggest there's no way to actually disable the CYCLE group.
    Last edited by Lazza; 12-17-11 at 08:24 PM.

  5. #5
    Newer Member Gerda 3's Avatar
    Join Date
    Dec 2011
    Location
    Germany
    Posts
    10
    right... this is my setting at the moment, but it isnīt the solution of my problem

  6. #6
    Registered Lazza's Avatar
    Join Date
    Oct 2010
    Location
    Australia
    Posts
    3,451
    Can I ask why you want to remove the cycling?

  7. #7
    Newer Member Gerda 3's Avatar
    Join Date
    Dec 2011
    Location
    Germany
    Posts
    10
    I build a german hillclimb track and if you drive trough the finish line the camera switches between the camera groups 1, 2, 3 if it is the camera group cycle...itīs not so a big problem, but it would be nice if i could disable the cycle group.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •